atmos:citation:instruments:buildelectricfieldmills:home
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| atmos:citation:instruments:buildelectricfieldmills:home [2026/07/17 16:08] – halmos | atmos:citation:instruments:buildelectricfieldmills:home [2026/08/04 16:20] (current) – halmos | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| * https:// | * https:// | ||
| ===== Log ===== | ===== Log ===== | ||
| + | * 8/4/26 - Circuit boards have arrived. Looked into SMD soldering and will need more solder, and a thin tip for the soldering iron. ESP32 board was a 38 pin instead of a 30 pin, so replacement part is being ordered and previous board is being returned. Looking into re-printing casing with ASA. | ||
| + | * 7/17/26 - Parts have been inventoried. Still waiting on CAP ALUM 330UF 20% 35V RADIAL and RES SMD 22K OHM 1% 1/8W 0805. Email sent to Shelby to order both the ESP32 dev-kit and M2 standoffs and screws. Waiting on those to arrive. | ||
| * 7/9/26 - Parts arrived from digikey. Shelby informed that two parts are on backorder. Waiting for 3D Printed parts as well as PCB's. Will inventory available parts next week. - Jacob Halmos. | * 7/9/26 - Parts arrived from digikey. Shelby informed that two parts are on backorder. Waiting for 3D Printed parts as well as PCB's. Will inventory available parts next week. - Jacob Halmos. | ||
| ===== Parts List ===== | ===== Parts List ===== | ||
| + | ===== To-do ===== | ||
| + | * Order PCB's | ||
| + | * Order ESP32 Dev-Kit | ||
| + | * Order M2 standoffs and screws* (see note) | ||
| + | * four a few mm long, plus 2 >20mm that will be cut apart | ||
| + | *3D print parts | ||
atmos/citation/instruments/buildelectricfieldmills/home.1784304485.txt.gz · Last modified: 2026/07/17 16:08 by halmos