atmos:citation:instruments:buildelectricfieldmills:home
Table of Contents
Build Electric Field Mills
Features
Github REPO with Instructions
Log
- 8/4/26 - Circuit boards have arrived. Looked into SMD soldering and will need more solder, and a thin tip for the soldering iron. ESP32 board was a 38 pin instead of a 30 pin, so replacement part is being ordered and previous board is being returned. Looking into re-printing casing with ASA.
- 7/17/26 - Parts have been inventoried. Still waiting on CAP ALUM 330UF 20% 35V RADIAL and RES SMD 22K OHM 1% 1/8W 0805. Email sent to Shelby to order both the ESP32 dev-kit and M2 standoffs and screws. Waiting on those to arrive.
- 7/9/26 - Parts arrived from digikey. Shelby informed that two parts are on backorder. Waiting for 3D Printed parts as well as PCB's. Will inventory available parts next week. - Jacob Halmos.
Parts List
To-do
- Order PCB's
- Order ESP32 Dev-Kit
- Order M2 standoffs and screws* (see note)
- four a few mm long, plus 2 >20mm that will be cut apart
- 3D print parts
atmos/citation/instruments/buildelectricfieldmills/home.txt · Last modified: 2026/08/04 16:20 by halmos