atmos:tripod:setup
This is an old revision of the document!
Setting up a new TIMM
In order to setup an new TIMM you will need a raspberry pi, A camera (can be usb or pi cam the instructions differ based on the camera), anemometer, and temperature/humidity sensor. This guide will walk you through the setup process.
1. The first step when setting up a new raspberrry pi can be found at the link below
2. Next you will need to setup the camera the next steps will be dependent on the camera you will be using. Below are the two options either the Pi Camera that plugs directly into the board or the USB camera.
3.1 Use this section if you are using the official pi camera that plugs directly into the board
3.2 USB Camera Setup
4. Live IP Video Stream setup
Accessing live IP video stream
- Must be connected to VPN if accessing from remote device.
- In firefox web browser search [http://127.0.1.1:8085/stream.html] to view live stream image.
5. Setting up the camera to take a picture automatically and transfer the images temporarily to aws then to calgary
- The ADPAA scripts save-img.sh and transfer+remove.sh are run by crontab to acquire and transfer images.
6. Setting up the 3d anemometer
atmos/tripod/setup.1731107561.txt.gz · Last modified: 2024/11/08 23:12 by delene