The TIMM system is a system used to operate the Tripod Instrumentation Meteorological Measurement instrument. In order to setup an new TIMM you will need a raspberry pi, A camera (can be usb or pi cam the instructions differ based on the camera), anemometer, and temperature/humidity sensor. This guide will walk you through the setup process.

1. The first step when setting up a new raspberrry pi can be found at the link below

• Raspberry Pi Setup Instructions

2. Next you will need to setup the camera the next steps will be dependent on the camera you will be using. Below are the two options either the Pi Camera that plugs directly into the board or the USB camera.

• Direct Link to Camera Images
• Raspberry Pi Camera Images Wiki
• Pi Camera Image Setup Wiki

• Raspberry Pi USB Camera Image Setup Wiki

• Raspberry Pi USB LiveStream
• Open Anydesk and open a new command line.
• Verify USB WebCam is connected and listed using “lsusb” command.
• Acquire the RasPi's IP address using the command “ifconfig” (127.0.1.1 for TIMMS SN00200)
• go to https://www.sigmdel.ca/michel/ha/rpi/streaming_en.html for instructions.

Accessing live IP video stream

• Must be connected to VPN if accessing from remote device.
• In firefox web browser search [http://127.0.1.1:8085/stream.html] to view live stream image.

• The ADPAA scripts save-img.sh and transfer+remove.sh are run by crontab to acquire and transfer images.
• Setup automation via cron jobs

• Setting up the Young 3d Sonic Anemometer