Atmos Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====Setting up a new Raspberry Pi system such as a TIMM system====

The TIMM system is a system used to operate the Tripod Instrumentation Meteorological Measurement instrument.
In order to setup an new TIMM you will need a raspberry pi, A camera (can be usb or pi cam; the instructions differ based on the camera), anemometer, and temperature/humidity sensor. This guide will walk you through the setup process.

1. The first step when setting up a new raspberrry pi can be found at the link below 


  * [[atmos:citation:instruments:raspberrypi_setup:home|Raspberry Pi Setup Instructions]]



2. Next you will need to setup the camera. The next steps will be dependent on the camera you will be using. Below are the two options: either the Pi Camera that plugs directly into the board or the USB camera. 

===3.1 Use this section if you are using the official pi camera that plugs directly into the board===
  * [[http://camera.atmos.und.edu/calgary/MetTrailer_CAM/PiCamera/plots/Picamera-latest.jpg|Direct Link to Camera Images]]
  * [[http://camera.atmos.und.edu/picam100.html|Raspberry Pi Camera Images Wiki]]
  * [[atmos:citation:instruments:raspberrypi_camera:home|Pi Camera Image Setup Wiki]]


===3.2 USB Camera Setup===
  *[[atmos:citation:instruments:USB_Camera:home|Raspberry Pi USB Camera Image Setup Wiki]]
===4. Live IP Video Stream setup===
  *[[atmos:citation:instruments:USB_Camera_LiveStrea.:home|Raspberry Pi USB LiveStream]] 
  *Open Anydesk and open a new command line.
  *Verify USB WebCam is connected and listed using "lsusb" command.
  *Acquire the RasPi's IP address using the command "ifconfig" (127.0.1.1 for TIMMS SN00200)
  *go to [[https://www.sigmdel.ca/michel/ha/rpi/streaming_en.html]] for instructions.
Accessing live IP video stream
  *Must be connected to VPN if accessing from remote device.
  *In firefox web browser search [http://127.0.1.1:8085/stream.html] to view live stream image.
===5. Setting up the camera to take a picture automatically and transfer the images temporarily to aws then to calgary===
  * The ADPAA scripts save-img.sh and transfer+remove.sh are run by crontab to acquire and transfer images.
  *[[atmos:citation:instruments:USB_Camera_automation:home|Setup automation via cron jobs]]

===6. Setting up the 3d anemometer===
  *[[atmos:citation:instruments:Setup_Young_Anemometer:home|Setting up the Young 3d Sonic Anemometer]]