Atmos Wiki

User Tools

Site Tools

Trace: • home • documentation2010 • setup • oid_instrument_log • cpi_instrument_log • usb_stream • home • serialaimms • vnc • housekeeping
atmos:tripod:setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
atmos:tripod:setup [2024/11/08 23:35] – deleneatmos:tripod:setup [2025/11/25 01:55] (current) – ashley.vos
Line 2: Line 2:
  
 The TIMM system is a system used to operate the Tripod Instrumentation Meteorological Measurement instrument. The TIMM system is a system used to operate the Tripod Instrumentation Meteorological Measurement instrument.
-In order to setup an new TIMM you will need a raspberry pi, A camera (can be usb or pi cam the instructions differ based on the camera), anemometer, and temperature/humidity sensor. This guide will walk you through the setup process.+In order to setup an new TIMM you will need a raspberry pi, A camera (can be usb or pi cam; the instructions differ based on the camera), anemometer, and temperature/humidity sensor. This guide will walk you through the setup process.
  
 1. The first step when setting up a new raspberrry pi can be found at the link below  1. The first step when setting up a new raspberrry pi can be found at the link below 
Line 11: Line 11:
  
  
-2. Next you will need to setup the camera the next steps will be dependent on the camera you will be using. Below are the two options either the Pi Camera that plugs directly into the board or the USB camera. +2. Next you will need to setup the camera. The next steps will be dependent on the camera you will be using. Below are the two options: either the Pi Camera that plugs directly into the board or the USB camera. 
  
 ===3.1 Use this section if you are using the official pi camera that plugs directly into the board=== ===3.1 Use this section if you are using the official pi camera that plugs directly into the board===
Line 34: Line 34:
   *[[atmos:citation:instruments:USB_Camera_automation:home|Setup automation via cron jobs]]   *[[atmos:citation:instruments:USB_Camera_automation:home|Setup automation via cron jobs]]
  
-===6. Setting up the 3d anemometer=== +===6. Setting up Instruments=== 
-  *[[atmos:citation:instruments:Setup_Young_Anemometer:home|Setting up the Young 3d Sonic Anemometer]]+ 
 +  *Setting up the 3d anemometer - [[atmos:citation:instruments:Setup_Young_Anemometer:home|Setting up the Young 3d Sonic Anemometer]] 
 +  *Setting up the Vaisala Temperature and Humidity Probe - [[atmos:citation:instruments:Setup_Vaisala Temperature and Humidity Probe:home|Setting up the Vaisala Temperature and Humidity Probe]]
atmos/tripod/setup.1731108917.txt.gz · Last modified: 2024/11/08 23:35 by delene