Differences

This shows you the differences between two versions of the page.

--- atmos:tripod:setup [2024/11/08 23:25] – delene
+++ atmos:tripod:setup [2025/10/03 02:53] (current) – ashley.vos
@@ Line 1: / Line 1: @@
-====Setting up a new TIMM====
+====Setting up a new Raspberry Pi system such as a TIMM system====
-In order to setup an new TIMM you will need a raspberry pi, A camera (can be usb or pi cam the instructions differ based on the camera), anemometer, and temperature/humidity sensor. This guide will walk you through the setup process.
+The TIMM system is a system used to operate the Tripod Instrumentation Meteorological Measurement instrument.
+In order to setup an new TIMM you will need a raspberry pi, A camera (can be usb or pi cam; the instructions differ based on the camera), anemometer, and temperature/humidity sensor. This guide will walk you through the setup process.
 . The first step when setting up a new raspberrry pi can be found at the link below
@@ Line 10: / Line 11: @@
-. Next you will need to setup the camera the next steps will be dependent on the camera you will be using. Below are the two options either the Pi Camera that plugs directly into the board or the USB camera.
+. Next you will need to setup the camera. The next steps will be dependent on the camera you will be using. Below are the two options: either the Pi Camera that plugs directly into the board or the USB camera.
 ===3.1 Use this section if you are using the official pi camera that plugs directly into the board===