atmos:tripod:home
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
atmos:tripod:home [2024/05/20 18:44] – delene | atmos:tripod:home [2025/03/07 20:33] (current) – delene | ||
---|---|---|---|
Line 8: | Line 8: | ||
| | ||
===Instruments Installed=== | ===Instruments Installed=== | ||
- | * [[http:// | + | * [[atmos: |
* Anydesk (875 427 442) | * Anydesk (875 427 442) | ||
Line 25: | Line 25: | ||
===Initial Raspberry Pi Setup=== | ===Initial Raspberry Pi Setup=== | ||
- | * * [[http:// | + | * * [[atmos: |
===Pi Camera Setup=== | ===Pi Camera Setup=== | ||
==Use this section if you are using the official pi camera that plugs directly into the board== | ==Use this section if you are using the official pi camera that plugs directly into the board== | ||
* [[http:// | * [[http:// | ||
* [[http:// | * [[http:// | ||
- | * [[http:// | + | * [[atmos: |
===USB Camera Setup=== | ===USB Camera Setup=== | ||
- | *[[http:// | + | *[[atmos: |
===Setting up the camera to take a picture automatically=== | ===Setting up the camera to take a picture automatically=== | ||
* The ADPAA scripts save-img.sh and transfer+remove.sh are run by crontab to acquire and transfer images. | * The ADPAA scripts save-img.sh and transfer+remove.sh are run by crontab to acquire and transfer images. | ||
- | *[[http:// | + | *[[atmos: |
===Setting up a new TIMM=== | ===Setting up a new TIMM=== | ||
- | *[[http:// | + | *[[atmos: |
===Meteorological Measurements Setup=== | ===Meteorological Measurements Setup=== | ||
Acquisition is provided on the Raspberry Pi using the python program of IMetX!2_try.py, | Acquisition is provided on the Raspberry Pi using the python program of IMetX!2_try.py, |
atmos/tripod/home.1716230655.txt.gz · Last modified: 2024/05/20 18:44 by delene