Differences

This shows you the differences between two versions of the page.

--- atmos:instruments:dc_wiring [2025/12/11 22:43] – johansen
+++ atmos:instruments:dc_wiring [2025/12/11 22:47] (current) – johansen
@@ Line 12: / Line 12: @@
    * {{:atmos:instruments:solder.png?400|}}
-   * separate the cables enough so the heat shrink is far enough away from the soldering iron to not melt
+   * Separate the cables enough so the heat shrink is far enough away from the soldering iron to not melt
    * Keep the solder heat setting at or below 38 so as to not risk melting the plastic casing (This is more of an issue on the smaller male connector but its good practice to follow on both connectors)
    * After soldering the female plug to the powered cable, you can solder the male plug to the cable connected to the instrument
-   * plug the connectors together and use a multimeter to test for continuity.
+   * Plug the connectors together and use a multimeter to test for continuity across the plug. The multimeter should not show "Lo" when testing
    * Once both connectors have been soldered and you tested for continuity, place the heat shrink over the exposed connection of each plug and use the heat gun to seal the soldered connections
    * try to cover the entire connection so as to not have any exposed metal