atmos:citation:instruments:setup_young_anemometer:home
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| atmos:citation:instruments:setup_young_anemometer:home [2026/01/28 01:24] – ashley.vos | atmos:citation:instruments:setup_young_anemometer:home [2026/01/28 01:36] (current) – ashley.vos | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| ===Parts=== | ===Parts=== | ||
| * Instrument | * Instrument | ||
| - | picutre of anemiotie | + | {{: |
| * Wiring Box | * Wiring Box | ||
| - | picture of wireing box, picure of pi | + | {{: |
| * Wires - While the color will ultimately depend on the cord you use to wire the instrument, the colors shown here are just for easy reference to the different power signals. | * Wires - While the color will ultimately depend on the cord you use to wire the instrument, the colors shown here are just for easy reference to the different power signals. | ||
| + | {{: | ||
| + | {{: | ||
| * Red - Power (positive) | * Red - Power (positive) | ||
| * Blue - Power (Ground, negative) | * Blue - Power (Ground, negative) | ||
| Line 50: | Line 52: | ||
| * a fan | * a fan | ||
| - | - Wire the Anemometer' | + | - Wire the Anemometer' |
| - Red to +PWR | - Red to +PWR | ||
| - Blue to EARTH GND | - Blue to EARTH GND | ||
| Line 65: | Line 67: | ||
| - You should see some voltage coming through on the voltmeter. | - You should see some voltage coming through on the voltmeter. | ||
| - Wire the probe into the DAQ HAT | - Wire the probe into the DAQ HAT | ||
| - | | + | - Grey to CH0 |
| - | - Blue to EARTH GND | + | - Yellow to CH1 |
| - | | + | - Green to CH2 |
| - | - Yellow to V2 | + | - White to CH3 |
| - | - Green to V3 | + | - Brown to GND |
| - | - White to V4 | + | |
| - | - Brown to VREF | + | |
| - If you have properly set up the ADPAA and DAQ HAT, you can now run the python program that coincides with your instrument and observe the data. | - If you have properly set up the ADPAA and DAQ HAT, you can now run the python program that coincides with your instrument and observe the data. | ||
| ===NOTE: Remember, Wire Colors in this page are arbitrary.=== | ===NOTE: Remember, Wire Colors in this page are arbitrary.=== | ||
atmos/citation/instruments/setup_young_anemometer/home.1769563492.txt.gz · Last modified: 2026/01/28 01:24 by ashley.vos