atmos:citation:instruments:setup_veinasa_visibility_sensor:home
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| atmos:citation:instruments:setup_veinasa_visibility_sensor:home [2026/07/27 17:37] – ashley.vos | atmos:citation:instruments:setup_veinasa_visibility_sensor:home [2026/07/27 17:37] (current) – ashley.vos | ||
|---|---|---|---|
| Line 31: | Line 31: | ||
| - Connect the yellow wire to T/R+ | - Connect the yellow wire to T/R+ | ||
| - Connect the green wire to T/R- | - Connect the green wire to T/R- | ||
| - | - Connect the extra wire to GND, and the negative connection on the DC power jack, as shown above. | + | - Connect the extra wire to GND and the negative connection on the DC power jack, as shown above. |
| - If you have properly set up the ADPAA, you can now run the python program that coincides with your instrument and observe the data. | - If you have properly set up the ADPAA, you can now run the python program that coincides with your instrument and observe the data. | ||
atmos/citation/instruments/setup_veinasa_visibility_sensor/home.1785173841.txt.gz · Last modified: 2026/07/27 17:37 by ashley.vos