Differences

This shows you the differences between two versions of the page.

--- atmos:citation:instruments:raspberrypi_setup:home [2024/10/28 13:56] – delene
+++ atmos:citation:instruments:raspberrypi_setup:home [2025/03/07 20:21] (current) – delene
@@ Line 1: / Line 1: @@
-===Intial Raspberry Pi setup instructions===
+===Intial Raspberry Pi Setup Instructions===
   - Change the hostname to TIMMS-SN00XXX. Example for TIMMS with a serial number SN00200 in the command line use "sudo vi /etc/hostname TIMMS-SN00200" without parentheses "sudo vi etc/hostname TIMMS-SN00200".
   - Update the base raspberry pi software using the command "sudo apt-get update" to check available updates then "sudo apt upgrade" to perform the updates.  Example: sudo apt-get update
@@ Line 5: / Line 5: @@
   - Set Password to standard password (if you don't know the standard password ask Dr. Delene).
   - Add the sourceforge ADPAA repository to the raspberry pi home directory.
+  - Setup crontab to reboot each day.  See [[https://forums.raspberrypi.com/viewtopic.php?t=126106|https://forums.raspberrypi.com/viewtopic.php?t=126106]]
+    - Reboot should set to 00:00Z.
+    - Daily rsync should be set to 00:01Z
 After these steps are done move onto setting up the camera depending on which type of camera is being used back on the main tripod page