Atmos Wiki

User Tools

Site Tools

Trace: • home
atmos:citation:instruments:e100:home

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
atmos:citation:instruments:e100:home [2026/02/13 16:17] – [Images] johansenatmos:citation:instruments:e100:home [2026/02/13 16:22] (current) – johansen
Line 34: Line 34:
   * Cut the plug off the end of the extension cord and feed the cable through the cable gland ( do not tighten the gland yet)   * Cut the plug off the end of the extension cord and feed the cable through the cable gland ( do not tighten the gland yet)
   * Separate and strip the cables of the extension cord and connect them to a new male plug (middle is always ground, use a multimeter to test for conductivity between the new plug and the outlets on the extension cord to determine which cable is hot and which is neutral, the large slot on the outlet is neutral)   * Separate and strip the cables of the extension cord and connect them to a new male plug (middle is always ground, use a multimeter to test for conductivity between the new plug and the outlets on the extension cord to determine which cable is hot and which is neutral, the large slot on the outlet is neutral)
-  * Check for conductivity between all three legs of the plug and their respective slots on the outlet+  * Check for conductivity between all three blades of the plug and their respective slots on the outlet (make sure the power switch on the extension cord is closed or there will be no continuity between the hot sides of the cable)
   * Strip off one end of the 18-20 AWG wire and add a ring terminal to the end of that wire   * Strip off one end of the 18-20 AWG wire and add a ring terminal to the end of that wire
   * Cut the wire to 6 inches and strip the other end   * Cut the wire to 6 inches and strip the other end
Line 40: Line 40:
   * Strip off one end on a new 18-20 AWG wire and add a ring terminal to the end   * Strip off one end on a new 18-20 AWG wire and add a ring terminal to the end
   * Cut the wire to 6 inches and strip the other end   * Cut the wire to 6 inches and strip the other end
-  * Loosen on of the 4 outer allen head screws on the top (inside the enclosure) of the EFR and secure the stripped end of the new wire to the loosened allen head and tighten it, tug on the wire to ensure it is secure+  * Loosen one of the 4 outer allen head screws on the top (inside the enclosure) of the EFR and secure the stripped end of the new wire to the loosened allen head and tighten it, tug on the wire to ensure it is secure
   * Take the ring terminals of both wires and place them on the stud at the top of the enclosure near the door   * Take the ring terminals of both wires and place them on the stud at the top of the enclosure near the door
   * The enclosure should have came with a yellow grounding cable that has ring terminals on both ends, locate this cable and place one end on the stud in the enclosure and the other end on the stud on the back of the door and place a nut on both studs   * The enclosure should have came with a yellow grounding cable that has ring terminals on both ends, locate this cable and place one end on the stud in the enclosure and the other end on the stud on the back of the door and place a nut on both studs
atmos/citation/instruments/e100/home.1770999476.txt.gz · Last modified: 2026/02/13 16:17 by johansen