Differences

This shows you the differences between two versions of the page.

--- atmos:3d-paws:home [2025/11/18 18:43] – johansen
+++ atmos:3d-paws:home [2025/11/18 19:29] (current) – [Current Stations] johansen
@@ Line 14: / Line 14: @@
   *[[atmos:3d-paws:und00300|UND 00300]]
   *[[atmos:3d-paws:und00400|UND 00400]]
+=== Grafana Config ===
+  *[[Guide to Grafana]]
 ==== Hardware 3D-PAWS ====
@@ Line 24: / Line 26: @@
   * Current slicer: Ultimaker Cura
-=== Grafana Config ===
-*[[guide to Grafana]]
 ==== Software - SD Cards ====
   * Command to write image to SD card on Linux, where /dev/mmcblk0 is the device of the card on the system.